Adjust the pitch of the alignment plate for stapling on the saddle stitcher to reduce misalignment and distortion in the paper stack.
Make this adjustment when misalignment or distortion occurs on the paper stack during stapling.
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required options | SaddleStitcher SD-506 | ||
Required items | - | ||
Setting items | [Offset for All Size] | Adjusts the alignment pitch common to all sizes. | |
Paper size selection key | Adjusts the alignment pitch in use of each size. | ||
[+] / [,] | Switches the paper size page. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment] - [Staple Paper Width Adj.] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment] - [Staple Paper Width Adj.] |
A sample is output.
Before printing, always pull out the Fold/Staple mode tray. Otherwise, a sample is not output even if you press Start on the Control panel.
a: Misalignment occurs if the specified paper width is wider than the paper width.
b: A distortion occurs If the specified paper width is narrower than the actual paper width.
Standard value: a = 1 mm or less
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
The following setting conditions are provided depending on the paper size.
Staple paper width | Minimum value | Maximum value |
---|---|---|
to 222 mm | 91 mm | (Paper width) -91 mm |
222 mm to 290 mm | No condition | No condition |
290 mm to | No condition | 165 mm |
For SaddleStitcher SD-506, when the paper width of a paper size such as [A4w] is less than 222 mm and the staple pitch is 91 mm or less, the staple pitch is set to 91 mm automatically.