Selecting Pre-Created Reference Images and Performing Automatic Inspections

When using reference images that have already been created to perform automatic inspections, select the image from the list and print the job.

Tips

• Textured paper, unprinted insertion paper, paper with punch holes, tab paper, and insertion paper are not subject to automatic inspections.
• You can perform inspections when using paper with the numbering and page numbers already printed on it, or when using the stamp copying function for the date and time, by specifying the areas not targeted for inspection. For details, refer to Automatic Inspection Area.

The following is an example of the procedure how to configure settings using the AccurioPro Print Manager.

1

Select a [Hold] job list in AccurioPro Print Manager.

• For details about how to access AccurioPro Print Manager, refer to AccurioPro Print Manager.

2

Select a held print job, and then press [Job Management] followed by [Job Settings...].

3

Enable [Auto Inspection] from the [Quality] tab.

4

Proceed to the automatic inspection. Select the [Quality] tab, and configure the items.

• For details about the settings, refer to the [Quality] tab settings (described after the procedure).

5

Press [Print] to start the print job and begin automatic inspection.

• If an abnormality is detected during the inspection, it is displayed on the [MACHINE] and [IQ Detected Result] screens on the system’s Touch panel. For details, refer to [IQ Detected Result].

• You can check the automatic inspection reports using the system’s Touch panel or from Web Utilities on Auto Inspection Unit UK-301.

Reference

• For details about automatic inspection reports, refer to Automatic Inspection Reports.

[Quality] tab settings