[CUT SETTING]
Overview
Set the finishing size for Multiple Cutting, the cut positions at the leading edge and rear edge, and the cut width in the center. The numeric values at the trailing edge and front edge are calculated automatically.
c: [Leading Edge]
d: [Rear Edge]
e: [Cut Width(lengthwise)]
Tips
- Enter the numeric value, referring to [Permitted range]. For details about how to change [Permitted range], contact your service representative.
If [Cut in Two] is selected, the paper is cut in the center.
Setting Items
Setting item | Description |
|---|---|
[Cut in Two] | Cuts the paper in the center. The numeric value is not set. |
[Finished Size] | Select the finishing size. |
[Leading Edge] | Sets the cut position at the leading edge using the value from the lead edge of paper. WY1: Set the value in the range of 10 mm to 13 mm / 0.39" to 0.51", and also set the cutting amount at the trailing edge in the range of 10 mm to 13 mm / 0.39" to 0.51". WY2: Set the value in the range of 8.0 mm to 16 mm / 0.31" to 0.63", and also set the cutting amount at the trailing edge in the range of 8.0 mm to 16 mm / 0.31" to 0.63". Unit: 0.1 mm / 0.004" |
[Trailing Edge] | The trailing edge position is automatically calculated from the paper size (widthwise), finishing size, leading edge position, and gutter slit width (vertical direction). Trailing edge position = Paper size (widthwise) - Finishing size (width) - Leading edge position - Gutter slit width (vertical direction) |
[Rear Edge] | Sets the cut position at the rear edge using the value from the upper edge of paper. Set the value in the range of 8.0 mm to 26 mm / 0.31" to 1.02", and also set the difference between the rear and front side positions in the range of 10 mm / 0.39". Unit: 0.1 mm / 0.004" |
[Front Edge] | The front edge position is automatically calculated from the paper size (lengthwise), finishing size (height and width), and rear edge position. Front edge position = Paper size (lengthwise) - Finishing size (height and width) - Rear edge position |
[Cut Width(lengthwise)] | Sets the cut width of the center. WY1: Set the value in the range of 0 mm / 0" or 5.0 mm to 13 mm / 0.20" to 0.51". WY2: Set the value in the range of 0 mm / 0" or 5.0 mm to 16 mm / 0.20" to 0.63". Unit: 0.1 mm / 0.004" |
[Disabled] | To enable [Cut Width(lengthwise)], clear the check box. |
[Complete] | Creates a trimmer profile with the specified value. |
[Cancel] | Cancels the setting, and returns to the previous screen. |
You can download the trimming image with the dimensions displayed on the profile creation screen as a PDF file. This is displayed when accessed from Web Connection or Web Utilities. |
in the upper-right of a page, it turns into 
and is registered as a bookmark.